Click on image to enlarge
Gluing and screwing the top, bottom,
and brace to one side.
Click on image to enlarge
Click on image to enlarge
|
Click on image to enlarge Gluing and screwing the top, bottom, and brace to one side. |
Click on image to enlarge |
Click on image to enlarge |
Click on image to enlarge Detail of the brace (same as used on all G-R speakers in this project). |
Click on image to enlarge Assembled crossover parts on ¼" Masonite Peg Board, since there are so many parts, used both sides of the board. Top & bottom views above. Also insured board would fit through driver hole in front.
|
Click on image to enlarge Temporarily installed crossover on wood dowels used as stand-offs. Taped cardboard over the cutouts in the rear panel to keep sawdust etc. from inside of box during construction and finishing. |
Click on image to enlarge Front is glued and screwed to the box, and driver hole is cut. |
Click on image to enlarge ½" MDF is added to the front. |
Click on image to enlarge ¼" Oak plywood has been added to all sides, and solid oak moldings have been added to all edges. "Egg Crate" foam has been installed and cabinet finished. |
Click on image to enlarge A/V-1s are finished and are to be used as Side speakers in a 7.1 home theater system. |
Click on image to enlarge Rear view of the finished A/V1s. |